SimplyPats User Forum

SimplyPats Portable Appliance Testing Software
It is currently Wed Feb 20, 2019 8:26 pm

All times are UTC [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Feb 03, 2019 12:01 am 
Offline

Joined: Fri Jun 29, 2018 1:02 pm
Posts: 1
Hi Everyone

I have got a megger pat 4 DV/3 and would like to print bar-code and pass labels but the bar code printers are very rare and expensive.

I have attached a Epson printer t88iii receipt printer but all i get out is a load of gibberish
and occasionally one line of the same gibberish

Richard do you know if any one else uses different printers and if so what cable out puts and setting etc

Thanks Folks
For any input most welcome


Top
 Profile  
 
PostPosted: Sun Feb 03, 2019 9:56 pm 
Offline
Site Admin
User avatar

Joined: Wed Jan 23, 2008 11:47 pm
Posts: 1104
Location: Cornwall
Hi Patmadd

Its been a very long time since I've done any direct printing from a Pat4DV/3 and then it was using the parallel port direct to an old dot matrix printer.

The Epson T88iii almost certainly uses ESC/POS (Sequences of characters proceeded by the ESC character) in order to tell the printer what to do. I would be suprised if the Megger had these inbuilt in order to drive this specific printer correctly.

Although I have done alot of work on the PAT4 since 1998 I have never seen anyone use a printer with it. Apparently there was an M863 thermal? printer which connected via a Parallel adapter to Serial RS-232 (not sure how available and how much one of these cost?) perhaps worth keeping an eye out on auction sites?

We have a free android and ios app which you could use to print labels (barcode in code 39 format) which could be scanned by the Megger PAT4 but you would have to enter the same asset id in the tester as well as the app. If you are not downloading the Megger PAT4 data to software then this might be useful?

Sorry I cant shed more light on the subject, maybe someone on here has had more experience of label printers with this machine?

Regards, Richard.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group